When this option is on, a “Paper” layer will be added to the new canvas. Paper color: For this option to be active, the checkbox to the left must be checked. So if you create a monochrome canvas but then decide to color the image, you can create a color layer later on. Though this option sets the default expression for the image that will be created, individual layers can be set to different expression modes. The options are Color, Gray, and Monochrome. The drop-down to the right of the Resolution box allows for a selection of common resolution numbers.īasic expression color: Choose the basic expression color for the image. 72 dpi is the resolution for internet display, but resolution this low produces a pixelated, blurry printed outcome. Artwork that will be monochrome (black and white only) can be as high as 600 dpi if your computer hardware can handle it. Any project that will be printed should be set for a minimum of 300 dpi so the print comes out clearly. Resolution: Sets the resolution of the image. For instance, if the settings are currently for an 8 by 10 inch canvas, clicking this icon will turn it into a 10 by 8 inch canvas instead. Note that the double-ended arrow button to the left of the Width and Height can be used to swap the current width and height numbers. Height: Sets the height of the canvas that will be created. Width: Sets the horizontal width of the canvas that will be created. Several different units of measurement are included in this option, including CM, Inches, and Pixels. Unit: The unit of measurement that will be displayed in the “Canvas” area. Register to Preset Option: Clicking this option to the right of the Preset drop-down will save the current settings to a Preset that can be used again later.ĭelete Preset: Clicking this “trash can” icon deletes the currently selected User saved preset. This is also where any settings saved by the user can be found. These sizes change depending on which Use of work category is selected currently. Preset: This dialog box allows you to choose from several common sizes of canvas. This is what name Clip Studio Paint will try to save your file as by default when hitting the Save option while working. These options are highlighted by the arrow in the following screenshot.īelow are the descriptions of each option in this dialog box.įile name: Enter the name of your file here. The rest of this article will be grouped according to the categories under the “Use Of Work” options at the top of the New dialog box. Once inside the CSP software, you can press Ctrl+N on the keyboard, or selected File - New to start making a new document. To open the options for creating a new file, you will need to open the Clip Studio Paint software. If you are only interested in learning about the options for creating comics, you can skip to the “Comic” section (or whatever other section you are interested in!) without having to read the entire article. Some of the options in different categories are the same, but I will repeat the descriptions of those options in the relevant categories. In this article, I will be covering each of the separate categories under the “Use of Work” category individually. The new file creation box can be more than a bit overwhelming at first glance, especially if you’re brand new to digital art in general! There are so many options and boxes to check, it can be difficult to figure out what everything does and what settings will be best for your project! One question I get asked a lot by users who are new to Clip Studio Paint is how to create a new file. Many of you probably know my name from those books, in fact! I was a beta-tester on the Manga Studio 5 program and for Clip Studio Paint, and I have written three books and several video courses about the program. Hello! My name is Liz Staley and I’m a long-time user of Clip Studio Paint (I started using the program back when it was known as Manga Studio 4!).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |